3D MODEL DESCRIPTION
The guide to the afterlife is here. If you’ve been brave enough, she’ll light your path to Valhalla.
Check out our technical overview: [CLICK HERE]
- This STL file is recommended for FDM Printers!
- 3D Printing Time: 13 Hours 18 Minutes
- Approximately Height : 14 cm
- In order to assembly this print you will need the materials below:
LED Lights (FLAT TOP)
On-Off Switch
Solder
Soldering Iron
Electric Wire
Electrical Plug (2.1mm DC Jack 12V)
Power Supply (12V 1A)
Electrical Tape
3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)
- Line Width/ Nozzle: 0.4 mm
- First Layer Line Width: 0.48 mm / 120%
- Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers)
- Recommended Initial Layer Height: 0.20 mm
- Recommended Layer Height: 0.20 mm
- Recommended Perimeters/ Walls: 3.
- Recommended Infill (%): 10% (Gyroid)
- Needs Support: No.
- Build Plate Adhesion: Skirt.
The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.
Happy Printing!
